Important Points; Operating Instructions - Poulan Pro 530165221 Instruction Manual

Upper Shaft
Coupler
LOOSEN
Lower
Attachment
TIGHTEN
2. Press and hold the locking/release button.
Locking/Release
Button
Coupler
Lower Attachment
3. While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupler.
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the attach-
ment (if present).
2. Position locking/release button of attach-
ment into guide recess of coupler.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler Primary Hole
Locking/
Upper
Release
Shaft
Button
WARNING:
Make sure the locking/
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit.
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for storage
when attachment is not in use.
To install hanger on attachment:
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release button.
3. Push hanger onto the attachment until the
locking/release button snaps into the hole.

OPERATING INSTRUCTIONS

It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.
OPERATING INSTRUCTIONS FOR
PRUNER ATTACHMENT
OPERATING POSITION
ALWAYS WEAR:
Head
Protection
Knob
Upper Shaft
DANGER:
shoulders while pruning. Do not stand be-
neath branch being cut.
WARNING:
hearing, foot and body protection to reduce
the risk of injury when operating this unit.
When operating unit, clip shoulder strap onto
clamp, stand as shown and check for the fol-
lowing:
S Extend your left arm and hold assist handle
with your left hand.
S Hold throttle grip with your right hand with
finger on throttle trigger.
S Keep engine end below waist level.
S Keep shoulder strap pad centered on your
Guide Recess
left shoulder and danger sign centered on
your back.
S Maintain full weight of tool on your left
shoulder.
Always release the throttle trigger and allow the
Attachment
engine to return to idle speed when not pruning.
To stop engine:
S Release the throttle trigger.
S Move the ON/OFF switch to the OFF posi-
tion.
PRUNING
WARNING:
against kickback. Do not allow the moving
chain to contact any other branches or ob-
jects at the nose of the guide bar when prun-
ing. Allowing such contact can result in seri-
ous injury.

IMPORTANT POINTS

S Work slowly, keeping both hands firmly
gripped on the pruner. Maintain secure
footing and balance.
S Plan cut carefully. Check direction branch
will fall.
S Watch out for springpoles. Springpoles are
small size limbs which can catch the chain
and whip toward you or pull you off balance.
Use extreme caution when cutting small size
limbs or slender material.
12
Eye
Protection
Long Pants
Heavy Shoes
Do not extend arms above
Always wear head, eye,
Be alert for and guard