Table of Contents
Advertisement
ATTACHING SHIELD
(for line trimmer attachment)
WARNING:
The shield must be prop-
erly installed. The shield provides partial protec-
tion from the risk of thrown objects to the opera-
tor and others and is equipped with a line limiter
blade which cuts excess line to the proper
length. The line limiter blade (on underside of
shield) is sharp and can cut you.
For proper orientation of shield, see KNOW
YOUR TRIMMER ATTACHMENT illustration in
OPERATION section.
1. Remove wing nut from shield.
2. Insert bracket into slot as shown.
3. Pivot shield until bolt passes through hole
in bracket.
4. Securely tighten wing nut onto bolt.
KNOW YOUR UNIT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments. Save this manual for future reference.
Pruner
Shaft
Line Trimmer
Attachment
Shield
Chain
Bar
RECESSED PLUG
The RECESSED PLUG is where you attach
your extension cord to the unit.
TRIGGER SWITCH
The TRIGGER SWITCH is used to turn on the
unit. Squeeze the trigger switch to operate the
unit. Release to stop.
OPERATING INSTRUCTIONS
Use only a voltage supply as specified on
your unit.
Shield
PIVOT
Line Limiter
Blade
OPERATION
Assist Handle
Coupler
Shoulder Strap Clamp
Attachment
Hanger
Motor Housing
Bar oil fill cap
Bar nut
COUPLER
The COUPLER enables optional attach-
ments to be installed on the unit.
CHAIN TENSION
It is normal for a new chain to stretch during
first 15 minutes of operation. You should
check your chain tension frequently. See
CHAIN TENSION in the SERVICE AND AD-
JUSTMENTS section.
SELECT AN EXTENSION CORD
Extension Cord Gauge Chart
Length of Cord
25 Ft. (7.5 m)
50 Ft. (15 m)
100 Ft. (30 m)
Extension cords are available for this unit.
11
Slot
Bracket
Wing
Nut
Recessed
Plug
Cord Retainer
Trigger Switch
Gauge
18 Gauge
16 Gauge
14 Gauge
Advertisement
Table of Contents
