Page 1
Lire le manuel d’instructions et bien respecter tous les avertisse- ments et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products, Inc. 104 Warren Road Augusta, GA 30907 Copyright E2004 Electrolux Home Products, Inc. Instruction Manual PP446T 530165221 7/16/04...
IDENTIFICATION OF SYMBOLS DANGER! This pruner can be dangerous! Careless or im- proper use can cause serious or even fatal injury. Always wear appropriate ear protection, eye protection and head protection. DANGER! Falling objects can cause severe head injury. Wear head protection when operating this unit.
Page 3
are fatigued, ill, or upset, or if you have taken alcohol, drugs, or medication. You must be in good physical condition and mentally alert. If you have any condition that might be aggravated by strenuous work, check with doctor before operating a pruner. S Do not operate the pruner with one hand.
S Maintain unit according to recommended procedures. Keep cutting line at proper length. S Use only 0.080″ (2 mm) diameter Poulan PRO® brand line. Never use wire, rope, string, etc. S Install required shield properly before using the unit.
could close a cut and pinch or fall into chain. S Use the Reduced- -Kickback Guide Bar and Low- -Kickback Chain specified for your unit. MAINTAIN CONTROL S Keep a good, firm grip on the pruner with both hands when the engine is running and don’t let go.
Handlebar EDGER SAFETY WARNING: Inspect the area to be edged before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by the blade or can wrap around the shaft. S Blade rotates momentarily after the trigger is released.
Page 7
the unit. Use the metal shield for all metal blade use. WARNING: Only use brushcutter at- tachments that provide a metal shield with proboscis nose. Proboscis nose S Use only specified blade and make sure it is properly installed and securely fastened. S Cut from your left to your right.
Page 8
ice, thaw the unit before thoroughly before attempting to operate under power. S Keep the rotor clear of debris. S Do not throw snow near other people. The snow thrower could propel small objects at high speed causing injury. S After striking a foreign object, stop the en- gine, disconnect spark plug and inspect the snowthrower for damage and repair if nec- essary before restarting unit.
under the upper shaft and align the upper and lower clamp screw holes. Upper Shoulder Strap Clamp POWERHEAD ATTACHMENT Lower Shoulder Strap Clamp Screws 4. Insert two screws into the screw holes. 5. Secure shoulder strap clamp by tighten- ing screws with a hex wrench. ADJUSTING THE ASSIST HANDLE WARNING: When adjusting the as-...
Page 10
The oil output is automatically metered during operation. Always fill the bar oil tank when you fill the fuel tank. Genuine PoulanR or Poulan PROR bar and chain oil is recommended to protect your unit against excessive wear from heat and fric- tion.
Starter Handle Choke Lever Primer Bulb Muffler 1. Set unit on a flat surface. 2. Move ON/OFF switch to the ON position. 3. Slowly press the primer bulb 6 times. 4. Move choke lever to FULL CHOKE by aligning lever with position shown on de- cal (see illustration below).
Coupler LOOSEN Lower Attachment TIGHTEN Knob 2. Press and hold the locking/release button. Locking/Release Button Coupler Upper Shaft Lower Attachment 3. While securely holding the engine and upper shaft, pull the attachment straight out of the coupler. INSTALLING OPTIONAL ATTACH- MENTS 1.
Page 13
the branch being pruned. If the chain hits the rear branch, damage to the unit may occur. S Be alert for springback. Watch out for branches that are bent or under pressure. Avoid being struck by the branch or the pruner when the tension in the wood fibers is released.
WARNING: Use minimum speed and do not crowd the line when cutting around hard objects (rock, gravel, fence posts, etc.), which can damage the trimmer head, become entangled in the line, or be thrown causing a serious hazard. S The tip of the line does the cutting. You will achieve best performance...
Page 15
FASTENERS AND PARTS S Spark Plug Boot S Air Filter S Housing Screws S Assist Handle Screw S Debris Shield CHECK FOR DAMAGED OR WORN PARTS Contact an authorized service dealer for re- placement of damaged or worn parts. S ON/OFF switch - - Ensure ON/OFF switch functions properly by moving the switch to the OFF position.
the OFF position, then clean all sawdust from the guide bar and sprocket hole. To maintain guide bar: S Move ON/OFF switch to the OFF position and disconnect spark plug. S Loosen and remove bar clamp nut and chain brake. Remove bar and chain from pruner.
2. Clean entire surface of hub and spool. 3. Replace with a pre-wound spool, or cut two lengths of 12-1/2 feet of 0.080″ (2 mm) di- ameter Poulan PROr brand line. WARNING: Never use wire, rope, string, etc., which can break off and become a dangerous missile.
Page 18
STORAGE WARNING: Perform the following steps after each use: S Allow engine to cool before storing or trans- porting. S Store unit and fuel in a well ventilated area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.
Page 19
WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below except remedies that require operation of the unit. TROUBLE CAUSE Engine will not 1. ON/OFF switch in start. OFF position. 2. Engine flooded. 3. Fuel tank empty. 4.
LIMITED WARRANTY ELECTROLUX HOME PRODUCTS, INC., warrants to the original purchaser that each new Poulan PROr brand gasoline tool or at- tachment is free from defects in material and workmanship and agrees to repair or replace under this warranty any defective gasoline product or attachment as follows from the original date of purchase.
Page 21
have any questions regarding your warranty rights and responsibilities, you should contact your nearest authorized service center or call ELECTROLUX HOME PRODUCTS, INC., at 1- -800- -554- -6723. WARRANTY PERIOD: Any warranted part which is not scheduled for re- placement as required maintenance, or which is scheduled only for regular inspection to the ef- fect of “repair or replace as necessary”...
Need help?
Do you have a question about the 530165221 and is the answer not in the manual?
Questions and answers