Operating Position; Operating Instructions - Poulan Pro 115270726 Instruction Manual

OPERATING THE COUPLER
This model is equipped with a coupler which
enables optional attachments to be installed.
The optional attachments are:
Edger . . . . . . . . . . . . . . . . . . . . . . .
Cultivator . . . . . . . . . . . . . . . . . . . .
Blower . . . . . . . . . . . . . . . . . . . . . .
Brushcutter . . . . . . . . . . . . . . . . . .
Pruner . . . . . . . . . . . . . . . . . . . . . .
WARNING:
Always stop unit and dis-
connect spark plug before removing or instal-
ling attachments.
REMOVING PRUNER ATTACHMENT
(OR OTHER OPTIONAL ATTACH-
MENTS)
CAUTION:
When removing or installing at-
tachments, place the unit on a flat surface for
stability.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Attachment
TIGHTEN
2. Press and hold the locking/release button.
Locking/Release
Button
Coupler
Lower Attachment
3. While securely holding the engine and
upper shaft, pull the attachment straight
out of the coupler.
INSTALLING OPTIONAL ATTACH-
MENTS
1. Remove the shaft cap from the attach-
ment (if present).
2. Position locking/release button of attach-
ment into guide recess of coupler.
3. Push the attachment into the coupler until
the locking/release button snaps into the
primary hole.
4. Before using the unit, tighten the knob se-
curely by turning clockwise.
Coupler Primary Hole
Guide Recess
Locking/
Upper
Release
Shaft
Button
WARNING:
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. All attachments are designed
MODEL:
to be used in the primary hole unless otherwise
PP1000E
stated in the applicable attachment instruction
PP2000T
manual. Using the wrong hole could lead to seri-
PP3000B
ous injury or damage to the unit.
PP4000C
PP5500P
Locking/Release
Button in Primary Hole
INSTALLING ATTACHMENT
HANGER
An attachment hanger is provided for storage
when attachment is not in use.
To install hanger on attachment:
LOOSEN
1. Remove the shaft cap from the attach-
ment (if present) and discard.
2. Press and hold the locking/release button.
3. Push hanger onto the attachment until the
locking/release button snaps into the hole.
Knob

OPERATING INSTRUCTIONS

It is recommended that the engine not be
operated for longer than 1 minute at full
throttle.

OPERATING POSITION

ALWAYS WEAR:
Head
Upper Shaft
protection
DANGER:
shoulders while pruning. Do not stand be-
neath branch being cut.
WARNING:
hearing, foot and body protection to reduce
the risk of injury when operating this unit.
Attachment When operating unit, clip shoulder strap onto
clamp, stand as shown and check for the fol-
lowing:
13
Make sure the locking/
Eye
protection
Long pants
Heavy
shoes
Do not extend arms above
Always wear head, eye,