Advertisement
MVP™ Driver QRG
Back Panel
Connections
1
2
Number
Description
DIP SWITCHES addresser that can address up to 4 Drivers.
Up = Off; Down = On.
You will identify each Driver's Sender address within the LED Studio
software application.
Note: The MVP™ Driver is the Sender, and the panels are the Receiver(s).
1
OUTPUT can be used to connect to the next MVP™ Driver. Use a 9-pin D-
2
Sub serial cable for connection (not included).
INPUT (don't use if #1) connection from the previous MVP™ Driver. Use
3
a 9-pin D-Sub serial cable for connection (not included).
U - MAIN OUT is the primary etherCON® signal output that connects to
4
the first MVP™ in a series.
Signal LED indicator flashes Green when the video connection signal is
5
being received by the MVP™ Driver.
Power LED indicator displays Red when power is being received by the
6
MVP™ Driver.
D - BACKUP is the secondary signal output and is pre-configured as a
backup that provides complete signal reproduction at 1024 X 512 pixels.
7
You can also configure both outputs to run separately providing a
resolution of up to 2048 x 640. This configuration eliminates the backup.
8
USB – DATA IN connects to the content software for addressing.
DVI-D – VIDEO IN connects to a video source. The DVI signal must be a
9
direct digital signal in. You cannot use an analog to digital adaptor.
10
Power On/Off
11
Plug 100 – 240 VAC 50/60 Hz
Disconnect power before connecting other equipment to the
MVP™ Driver.
3
4
5
6
Page 8 of 12
7
8
9
11
10
Advertisement
