Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Bosch AUTODOME IP 5000i IR
Summary of Contents for Bosch AUTODOME IP 5000i IR
- Page 1 AUTODOME IP 5000i IR NDP-5502-Z30L Installation Manual...
-
Page 3: Table Of Contents
AUTODOME IP 5000i IR Table of contents | en Table of contents Safety About this Manual Legal Information Safety Precautions Important Safety Instructions Safety Addendum Important Notices - Illumination Safety Important Notices Customer Support and Service Unpacking Product Description Mounting Accessories... -
Page 4: Safety
Legal Information Copyright This manual is the intellectual property of Bosch Security Systems, Inc. and is protected by copyright. All rights reserved. Trademarks All hardware and software product names used in this document are likely to be registered trademarks and must be treated accordingly. -
Page 5: Important Safety Instructions
Electrical Code (NEC)), Canadian Electrical Code, Part I (also called CE Code or CSA C22.1), and all applicable local codes. Bosch Security Systems, Inc. accepts no liability for any damages or losses caused by incorrect or improper installation. All-pole power switch - Incorporate an all-pole power switch, with a contact separation of at least 3 mm, into the electrical installation of the building. -
Page 6: Safety Addendum
Bosch or user-supplied). Notice! Bosch recommends the use of surge/lightning protection devices (sourced locally) to protect network and power cables and the camera installation site. Refer to NFPA 780, Class 1 & 2, UL96A, or the equivalent code appropriate for your country/region, and to local building codes. -
Page 7: Important Notices
AUTODOME IP 5000i IR Safety | en Cornea / Lens 1000 s 200 mm 2.19 Infrared Hazard Hazard Distance 279 mm Important Notices UL Disclaimer Underwriter Laboratories Inc. ("UL") has not tested the performance or reliability of the security or signaling aspects of this product. UL has only tested fire, shock and/or casualty hazards as outlined in Standard(s) for Safety for Information Technology Equipment, UL 60950-1 . -
Page 8: Customer Support And Service
| Safety AUTODOME IP 5000i IR Customer Support and Service If this unit needs service, contact the nearest Bosch Security Systems Service Center for authorization to return and shipping instructions. Service Centers Telephone: 800-366-2283 or 585-340-4162 Fax: 800-366-1329 Email: cctv.repair@us.bosch.com... -
Page 9: Unpacking
Verify that all the parts listed in the Parts List below are included. If any items are missing, notify your Bosch Security Systems Sales or Customer Service Representative. – Do not use this product if any component appears to be damaged. Please contact Bosch Security Systems in the event of damaged goods. –... -
Page 10: Product Description
AUTODOME IP 5000i IR Product Description Keep your security in focus with the many features of the AUTODOME IP 5000i IR camera. The camera is carefully tuned to deliver detailed 1080p60 HD images during daylight and full details under low-light or no light conditions with the intelligent IR illuminator. The illuminator automatically adjusts the IR intensity according to zoom and field of view to ensure that the scene is illuminated uniformly. -
Page 11: Mounting Accessories
AUTODOME IP 5000i IR Mounting Accessories | en Mounting Accessories Model Number Description Installation Location NDA-U-WMT Pendant wall mount Indoor walls (direct installation) Outdoor walls (onto NDA-U-PAx or NDA-U-WMP) NDA-U-PA0 Surveillance cabinet Indoor/outdoor walls NDA-U-PA1 (24VAC, 120VAC, or 230VAC) NDA-U-PA2... -
Page 12: Preparing Wiring
| Preparing Wiring AUTODOME IP 5000i IR Preparing Wiring Prepare and install all wiring for 24 VAC, PoE+ (Cat5e/Cat6), alarms, and audio as necessary. For 24 VAC, follow the recommendations for maximum cable distance and wire gage. Maximum cable distance in meters (feet) per minimum cable diameter The following table identifies the recommended transmission distance (maximum) in meters (feet), based on the specified wattage, per the minimum cable diameter (in mm²), when the... -
Page 13: Installing A Microsd Card (Optional)
AUTODOME IP 5000i IR Installing a microSD card (optional) | en Installing a microSD card (optional) Loosen the 2 Hex screws in the back of the camera housing. Remove the housing cover. 2× Insert the card into the slot. Replace the housing cover. - Page 14 | Installing a microSD card (optional) AUTODOME IP 5000i IR 2× 2017.08 | 1.0 | Installation Manual Bosch Security Systems...
-
Page 15: Installing A Surveillance Cabinet And Camera
AUTODOME IP 5000i IR Installing a Surveillance Cabinet and Camera | en Installing a Surveillance Cabinet and Camera The surveillance cabinet can attach directly to a wall, to a corner mount, or to a pole mount. To install the cabinet (power supply box), follow the instructions in the Surveillance Cabinet Installation Manual. - Page 16 | Installing a Surveillance Cabinet and Camera AUTODOME IP 5000i IR Secure the safety locking screw with the T15 Torx screwdriver. 2017.08 | 1.0 | Installation Manual Bosch Security Systems...
-
Page 17: Installing A Roof Mount And Camera
AUTODOME IP 5000i IR Installing a Roof Mount and Camera | en Installing a Roof Mount and Camera Installing the Roof Mount Determine the wall location on the roof for the camera and use the Parapet wall mount bracket as a template to mark the hole locations. -
Page 18: Attaching The Mounting Cap And The Camera
| Installing a Roof Mount and Camera AUTODOME IP 5000i IR Attach the Parapet Wall Bracket using at least six (6) stainless steel fasteners, three (3) on each side. (The bracket has eight (8) holes.) Be careful not to overtighten the fasteners because it may strip the threads. - Page 19 AUTODOME IP 5000i IR Installing a Roof Mount and Camera | en Place the top of the camera inside the mounting cap. Rotate the camera approximately 15 degrees in a clockwise direction to lock firmly into place. Secure the safety locking screw with the T15 Torx screwdriver.
- Page 20 | Installing a Roof Mount and Camera AUTODOME IP 5000i IR 2017.08 | 1.0 | Installation Manual Bosch Security Systems...
-
Page 21: Connection
AUTODOME IP 5000i IR Connection | en Connection Caution! Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a Backup Runtime of greater than 5 seconds for the power level as specified on the product datasheet. - Page 22 | Connection AUTODOME IP 5000i IR Label ID Description Cable Wire Color ALARM_IN1 Alarm In 1 White ALARM_IN2 Alarm In 2 Blue AUDIO OUT Audio Out Grey Ground Black AUDIO GND Audio Ground Green AUDIO IN Audio In Purple 2017.08 | 1.0 |...
-
Page 23: Maintenance
Never scrub the bubble with any abrasive material or cleaners. Bosch recommends cleaning the exterior of the bubble with NOVUS “No. 1” Plastic Clean & Shine (or equivalent), according to manufacturer’s instructions. Refer to www.novuspolish.com to order or to find a local distributor. -
Page 24: Decommissioning
11.2 Disposal Disposal Your Bosch product has been developed and manufactured using high- quality materials and components that can be reused. This symbol means that electronic and electrical devices that have reached the end of their working life must be disposed of separately from household waste. - Page 26 Bosch Security Systems B.V. Torenallee 49 5617 BA Eindhoven Netherlands www.boschsecurity.com © Bosch Security Systems B.V., 2017...