Bosch AUTODOME IP 4000i Installation Manual page 26

26 en | Installing an In-Ceiling Camera in a Drywall Ceiling
2.
3.
4.
Warning!
Over torquing the ceiling clamps can damage the clamp or ceiling. Only tighten the clamp
!
until it contacts the ceiling and you start to feel some resistance. If using a power
screwdriver, set the torque level to the lowest setting.
5.
2017.08 | 1.0 | F.01U.xxx.xxx
Insert the camera (without the trim ring / bubble enclosure) into the hole in the ceiling.
Ensure not to pinch the cables.
Turn each fastening screw to secure the clamps in the ceiling.
3×
Tighten the clamps using the Phillips screwdriver to secure the housing to the ceiling.
Place the trim ring / bubble enclosure in position over the camera block, aligning the
three (3) screws. Tighten the screws firmly to secure the trim ring / bubble enclosure to
the in-ceiling bracket.
Installation Manual
AUTODOME IP 4000i
Bosch Security Systems