Table of Contents
Advertisement
Diskette drive
Drive considerations:
•
•
Complete the following steps to remove and install a diskette drive in your server:
1. Review the information in "Before you begin" on page 9 and "Safety Information"
2. Turn off the server and disconnect the power cord from the back of the server.
3. Push the diskette drive eject button to the right.
4. Using the tab, pull the diskette drive partially out of the server; then, grasp the
5. Install the new diskette drive:
6. If you have other options to install or remove, do so now. Otherwise, connect the
Your xSeries 440 server supports the installation of up to two diskette drives.
If only one diskette drive is installed, it must be installed in the left drive bay.
on page 11.
Attention: The IDE drives installed in your server are not hot-swappable.
drive and remove it from the server.
a. Inspect the drive for any signs of damage.
b. Slide the drive into the left drive bay until it stops.
Note: In the unlikely event that no other IDE drives are installed, the diskette
drive must be installed in the right external removable media bay.
External removable
media bays
Diskette
drive
power cords and turn on the server.
Diskette drive
eject button
Tab
Chapter 2. Installing options
25
Advertisement
Table of Contents
