SPORTS ART DF-208 Owner's Manual page 30

STEP 11 Cable Adjustment
(a) After securing the cable nut onto the weight stack rod (A8). Make sure the
gap between the (X) and (Y) nut is within 40mm (1.6") and the (X) nut
is secured to a depth of 20mm at least. If the gap exceeds the 40mm limit,
the cable needs to be adjusted to the proper length to avoid it's come off.
(b) Insert the stack fork (47) into the gap under the lowest weight plate and
then adjust the nut (Y) until the upper stack carriage moves slightly.
To adjust the cable, first insert an open end wrench into (Z) hole. Loosen (Y)
nut and then adjust (X) nut. If the cable is too long, adjust (X) nut downward.
If too short, adjust (X) nut upward. After adjusting (X) nut, tighten (Y) nut
against the weight stack to secure this position.
(a)
(b)
29