Bosch ISC-CDL1-WA15G Reference Manual page 19

Commercial Series TriTech+ Motion Detector with
Anti-mask
The available resistance values are 1 kΩ, 2.2 kΩ, and 33 kΩ.
Notice!
When using single EOL loops, this resistor represents: EOL resistor. Refer to the control
panel documentation to verify whether individual outputs signaling different conditions
(alarm, tamper, or trouble) should be connected on the same loop. Single EOL loops with
multiple outputs connected in series with the resistor cannot determine which output
contacts opened the loop.
Figure 6.4: Tamper resistors overview �
Alarm loop jumper (pin block section 3) �
The selection pin labeled 3 is intended to complete the loop continuity when wired to control �
panels with the following configuration: triple EOL resistor. �
When placing a jumper across the pins, the tamper and trouble terminals adjacent to each �
other (from left to right the sixth (T) and seventh (TR) terminals) are connected (shorted). �
Notice!
When using the following configureation, use this jumper to complete the circuit: triple EOL
resistors.
Bosch Security Systems, Inc
NC NC T TR
T
NC NC
2
Reference Guide
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
TR
TR TR
T T
Wiring | en 19
12 k
4
2.2 k
J
3
33 k
2.2 k
2
1.0 k
2.2 k
1
1.0 k
2017.09 | 03 | F.01U.309.350