Bubble Level - Bosch ISC-CDL1-WA15G Reference Manual

Commercial Series TriTech+ Motion Detector with
Anti-mask
5.4

Bubble level

The detector's coverage pattern performs optimally when installed vertically. The detector
base includes a removable bubble level which helps you align the unit. Before drilling the
mounting holes in the surface, use the bubble level to align the detector.
Figure 5.6: Leveling the detector
Using the bubble level:
1. � Position the detector base on the surface and install it in place using one screw only. Do
not over-tighten the screw.
2. � Make sure the base is level from side to side.
3. � Remove the bubble level and place it into the round cavity on the right side of the base.
Make sure the base is level and not tipped forwards or back.
4. � Make adjustments until the base is level, and mark the remaining surface hole locations.
5. � Remove the bubble level and place it back to its original position.
Notice!
Do not leave the bubble level in the circular holder. You cannot properly place the detector �
body onto the mounting base with the bubble level in the circular holder. �
Do not use a bracket to tip the detector in any direction as it might cause false alarms or �
reduced catch performance. �
6. Secure the detector body with the remaining screws.
Bosch Security Systems, Inc � Reference Guide
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Installation | en 15
2017.09 | 03 | F.01U.309.350