Install Options - Bosch ISC-CDL1-WA15G Reference Manual

12 en | Installation
Figure 5.2: Putting the detector onto the base
5.2

Install options

The following table is an overview of install information and options.
Install directly to the surface
When installing onto a flat surface mounting, select the installation holes shown in the figure. �
Drill the holes or tap them out with a screwdriver. �
To use the wall tamper feature, use one of the installation holes shown in red in the following �
figure. �
2017.09 | 03 | F.01U.309.350
1
Install the detector using the detector base.
Install the detector on a flat wall or in a corner. Refer to .
Install the detector using a bracket. Refer to .
Detector coverage patterns are designed for optimal performance when
installed vertically. The detector base includes a removable bubble level
which helps you align the unit. Before drilling the installation holes, use
the bubble level to align the detector. Refer to Bubble level, page 15.
Reference Guide
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Commercial Series TriTech+ Motion Detector with
Bosch Security Systems, Inc
Anti-mask