Installation; Self-Locking Cam - Bosch ISC-CDL1-WA15G Reference Manual

Commercial Series TriTech+ Motion Detector with
Anti-mask
5

Installation

This section includes hardware details and the instructions you need to install the motion
detector base.
5.1

Self-locking cam

The detector includes a self-locking cam for easy installation. Refer to the following
information to open and close the detector.
Open the detector and remove the base
1. Insert a flathead screwdriver into the locking tab hole.
2. Turn to the unlock position.
3. Slide, then lift the detector from the base.
Figure 5.1: Unlocking the base and removing the detector
Put the detector onto the base
Notice!
When you remove the detector from the base, the cam automatically returns to the locked
position. When you place the detector onto the base, the cam must remain in locked position.
Do not manually change the cam once you remove the detector from the base; doing so
unlocks the detector and prevents you from putting the detector correctly onto to base.
1. Put detector onto the base.
2. Slide the detector up until you hear it "click."
Bosch Security Systems, Inc Reference Guide
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Installation | en 11
2017.09 | 03 | F.01U.309.350