Anti-Mask - Bosch ISC-CDL1-WA15G Reference Manual

Commercial Series TriTech+ Motion Detector with

Anti-mask

Notice!
The walk test switch does not affect the warm-up flash after power-up or any of the trouble
flash patterns. During the warm-up period, the blue LED flashes continuously until the unit
has stabilized (approximately 2 minutes) and has seen no movement for at least 5 seconds.
Enable or disable the walk test LED feature using the switch labeled 1.
1
1
Figure 7.2: Walk test LED switch settings
Callout - Description
1 – Walk test LED on
2 – Walk test LED off
The ON position enables the LED. If you do not want LED indication after you finish the setup
and walk tests, place the switch in the OFF position. The OFF position does not prevent the
LED from indicating supervision trouble conditions.
If you do not want the LED to light when the device detects a possible alarm event, disable
the LED after you complete the walk test.
Notice!
Some regulations require that you disable the LED after the walk test.
Automatic brightness
To improve LED visibility in any lighting environment, the walk test LED automatically changes
brightness. In dark environments, the LED intensity lessens; in bright environments, the LED
intensity increases.
7.3 Anti-mask
≤ 30 cm (1 ft)
≤ 30 cm (1 ft)
ISC-PDL1-WA18G
ISC-PDL1-WA18H
ISC-PDL1-WAC30G
Bosch Security Systems, Inc
2
1
ISC-PDL1-WAC30H
ISC-PPR1-WA16G
ISC-PPR1-WA16H
Reference Guide
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
Configuration and walk test | en
µWave
≤ 30 cm (1 ft)
ISC-PDL1-W18G
ISC-PDL1-W18H
2017.09 | 03 | F.01U.309.350
25