ALLIANCE BF3JGBJG403UN01 Original Instructions Manual page 108

Testing Machine and Electronic Control Functions
Display
drLo or drUL
CLdE
HoSF
PrSr
XXC or XXXF
oFLo
LoAg
rEAg
PUNP or drAi
RPM speed displayed
XXXX
©
Published by permission of the copyright owner -
DO NOT COPY or TRANSMIT
Test Mode
Door Lock Test
Cold/Detergent Fill
Hot/Softener Fill
Pressure Sensor Fill
Heater
Overflow Test
Low Agitate
Regular Agitate
Pump/Gravity Drain Test
Spin Test
Table 31 continues...
108
Comments
When step is entered, control will lock
door and will then check to make sure
door is locked. drLo is displayed if door
is locked. drUL is displayed if door is un-
locked.
Cold Water Fill valve and Detergent/
Bleach valve are turned on.
Hot Water Fill valve and Softener valve
are turned on.
This step checks the water level input.
The display shows PrSt, and all water
valves turn on. When the Water Fill Lev-
el is satisfied, the water valves are turned
off. If the Start key is pressed and the
Water Fill level is not satisfied, the con-
trol will not advance to the next cycle
step.
Heater temperature display in degrees
Celcius where XX is temperature or de-
grees Fahrenheit where XXX is tempera-
ture.
All water and dispenser valves are turned
on. When the overflow level is reached
the water valves are turned off. If the
START (enter) key is pressed and the
Water Fill level is not satisfied, the con-
trol will not advance to the next cycle
step.
Machine enters low agitate.
Machine enters regular agitate.
Pump is turned on or gravity drain is
opened. The control will not advance to
next step until drum is empty.
Machine will attempt to spin up to 1200
RPMs.
Part No. 805405ENR5