hpqlarep
Synopsis
hpqlarep
Description
The hpqlarep utility enables or disable the EFI or BIOS boot setting on QLogic 2 GB or 4 GB
HBAs.
Options
hpqlarep /s filename saves the HBA configuration to filename.
hpqlarep /l filename loads the HBA configuration to filename
Format
The configuration file for EFI boot setting has the following format:
•
For 2 GB HBAs
[HBA0]
WWID=11223344
SelectiveLogin=1
EnableSelectiveLUN=1
BootDeviceWWNN=2000000000000000 ; input from customer
BootDeviceWWPN=2200000000000000 ; input from customer
BootDeviceLUN[0]=0
•
For 4 GB HBAs
[HBA0]
WWID=11223344
SelectiveLogin=1
EnableSelectiveLUN=1 ; input from customer
BootDeviceWWPN=2200000000000000 ; input from customer
BootDeviceLUN[0]=0
NOTE:
Boot Target Device Node Name is not needed on 4 GB HBA. If SelectiveLogin and
EnableSelectiveLUN are both set to 0, the utility automatically clears out the
BootDeviceWWNN/BootDeviceWWPN and BootDeviceLUN (EFI database entries).
90
Utilities Reference
; section for each HBA - HBA No
; read-only variable
; input from customer
; input from customer
; input from customer
; section for each HBA - HBA No
; read-only variable
; input from customer
; input from customer
- HBA WWPN
- 1 (Enable) or 0 (Disable)
- 1 (Enable) or 0 (Disable)
- Boot Device Node name
- Boot Device Port name
– Boot Device LUN ID
- HBA WWPN
- 1 (Enable) or 0 (Disable)
- 1 (Enable) or 0 (Disable)
- Boot Device Port name
– Boot Device LUN ID
Need help?
Do you have a question about the Integrity rx1620 and is the answer not in the manual?