HP Integrity rx1620 Deployment Manual page 27

bootia64.conf
elilo.conf
elilo.efi
linux
rootfs.gz
• The data_files directory is a placeholder that is used to store configuration files and
SSTK log files.
acu.ini
conrep.dat
hba-qlogic.ini
hba-emulex.ini
log
• The drivers directory is the placeholder directory of OEM driver files. For example, to
properly load the Intel NIC drivers, you must place the drivers in the following directory:
Network/intelNIC/windows/2003-enterprise/
other-files/$OEM$/$1/PnPDrivers/Network/intelNIC/
• The software directory is the placeholder of applications copied to the HP Service Partition
or Windows tools that will be installed after the operating system is initially installed. Files
placed under software\EFI_TOOLS will be automatically copied to the HP Service
Partition.
NOTE:
When installing Windows through the "win" option, ACU runs with –internal
switch, which prevents overwriting Emulex or QLogic HBA configuration in a SAN (storage
area network) environment.
• The os directory contains a sample unattended installation answer file, which you can
customize for your deployments.
• The scripts directory contains the following shell scripts (typically, you can customize
the first set of scripts for each option in the SSTK main menu).
Deployment scripts:
capture.sh
deploy.sh
windows-setup.sh
acpi flag to the appropriate state single-pci-domain or windows and
then boots.
configuration file used to configure the boot loader and ACPI mode
configuration file for the Linux boot loader
Linux boot loader
Linux kernel
Linux root file system in a compressed file
The captured RAID configuration file. This file is created when the
readhwconfig option is executed on a target server with a
supported RAID controller. The acu.ini file is read when the
windows-setup.sh script is executed. This file is not included in
the sample file structure.
The conrep EFI variables output file. This file is created when the
readhwconfig option is executed.
The hpqlarep configuration file, used to enable or disable the EFI
boot setting on QLogic host bus adapters (HBAs). This file is also
captured when the readhwconfig option is executed, and applied
before installing Windows.
The hplpgfg configuration file, used to enable or disable the EFI
boot setting on Emulex HBAs. This file is also captured when the
readhwconfig option is executed, and applied before installing
Windows.
This folder stores log files. It is created during SSTK execution.
Runs the conrep, acu, and hpqlarep utilities, capturing the
hardware configuration and saving the results in the repository
under the data_files directory.
Replicates the captured information from the repository to the
target system.
Launches Windows installation by creating and formatting disk
partitions, copying the operating system files to the MSDATA
Unpack the toolkit 27