Mounting The Contactless Reader - VeriFone QX100 Installation Manual

QX100

8. Mounting the Contactless Reader

The QX100 is able to lie flat, at a 180° angle, with two key holes
on the bottom panel for mounting the reader on a wall.
When mounting the contactless reader, it must be
close enough to the POS terminal or ECR, for the
connecting cables, and in an easily accessible location
for the customer.
The recommended screws for mounting the QX100 are
flat head screws
approximately 4 mm (0.157 in) and head diameter of
approximately 8 mm (0.315 in).
The manual includes a drilling pattern in the back, for
your convenience.
To mount the QX100:
1. Drill two holes in the wall for screws, with a 5.5 cm
(2.165 in) between them, according to the drilling pattern.
2. Insert wall inserts with screws.
3. Adjust the mounting screw heads until they are firmly in
place.
4. Take the reader and face the bottom of the base towards
the wall, with the narrow part of the key hole facing
upwards.
5. Push the base, so that the mounting holes at the bottom of
the base are around the screw heads.
Installation Manual
Note
Note
with a thread diameter
Note
of
15