Battery Information; Low Battery Alert; Battery Replacement - AstroStart DSP611 Owner's Manual

Remote start & security systems, elite series
Hide thumbs Also See for DSP611:
Table of Contents

Advertisement

Battery Information

The 2-way remote 2621-TX*, is powered by two coin cell batter-
ies (CR-2016), and the 1-way remote 2611-TX, is powered by a
single coin cell battery (CR-2032). Operating range diminishes as
battery charge depletes.

Low Battery Alert

When unlocking the vehicle using a remote control with a low
battery charge, the system provides a notification by emitting a
third horn honk output (if connected). If confirmation chirps are
programmed off, the system still emits one horn honk when unlock-
ing. After performing a command with the remote control, sever-
al beeps play to indicate the battery/batteries need replacing.
Once the alerts begin, the remote control will remain operational
for several days but the battery/batteries should be replaced at
the earliest opportunity or failure to control the system may occur.

Battery Replacement

1.
Unscrew the hardware on unit rear and remove from hous-
ing (if present).
Use a small flat blade screwdriver and insert it into the slot
2.
located along the bottom of the remote, near the key ring.
Carefully pry open the case.
Gently slide out the used battery/batteries to remove it from
3.
the holding clip. Orient the new battery for the correct polar-
ity and insert into holding clip.
4.
Realign the case parts and snap together by pressing firmly
and evenly on the front and back. Reinstall screw (if present).
© 2017 Directed. All rights reserved.
7

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dsp621

Table of Contents