Table of Contents
Advertisement
Type I Camera
Figure 2-3 Fix the camera to the Ceiling
7. Connect the corresponding cables, such as power
cable and video cable.
8. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Type I Camera
0° to 75°
9. Fit the black liner back to the camera and tighten
the screws on the bubble of the dome camera to
finish the installation.
2.2 Wall Mounting with a Bracket
Before you start:
You need to purchase a wall mounting bracket
separately.
Steps:
1. Drill 4 screw holes in the wall according to the holes
of the bracket.
2. Attach the bracket to the wall by aligning the 4
screw holes of the bracket with expansion screws on
the wall.
3. Secure the bracket with 4 hex nuts and washers.
Figure 2-5 Install Wall Mounting Bracket
4. Refer to step 3 of 2.1 Ceiling Mounting to remove
dome camera's bubble and the black liner.
5. Attach the back box/base plate of the dome camera
to the wall mounting bracket and secure them with
supplied screws.
0° to 355°
0° to 355°
Figure 2-4 3-Axis Adjustment
Type I Camera
Advertisement
Table of Contents
