HIKVISION ColorVu Configuration Manual

Camera led supplement light

Configuration Guide of ColorVu

Camera LED Supplement Light

1 Brightness configuration of LED supplement light

Note:

1, When the camera is electrified, it is self-check at full power, and the supplement light is bright,

so avoid to stare at supplement light of camera;

2, LED supplement light will be locked in the light-on state for an hour after continuous switching

for 5 times in a short time due to manual test or ambient brightness change.

Path：【Configuration】-【System】-【System Settings】-【External Device】

LED light brightness can be set to Manual mode or Auto mode.

1. Select Manual mode in LED Light Brightness Adjustment;

Table of Contents

Do you have a question about the ColorVu and is the answer not in the manual?

Page 1 Configuration Guide of ColorVu Camera LED Supplement Light 1 Brightness configuration of LED supplement light Note: 1, When the camera is electrified, it is self-check at full power, and the supplement light is bright, so avoid to stare at supplement light of camera;...
Page 2 2. Adjust LED light Brightness during level 1-100, 0 means no brightness; 3. Startup default is level 15 (sample model is 50, order model is 15) 1.2.2 Auto mode 1. Select LED Light Brightness Adjustment mode with Auto, camera will detect ambient brightness automatically, adjusting the brightness of supplement light.
Page 3 2.1 Timing mode 1. Selecting Timing in LED Light On, camera will turn on/off the LED supplement light according to Start/End Time; 2. Setting schedule time according to application requirements. Start time should be earlier than End Time. Start Time can be on the previous day of End Time. 2.2 Auto mode 1.