Hitachi SF-P90XA Operating & Installation Instructions Manual page 13

How to use
the Tub Dry
program
How to use
the Tub Clean
program
Presetting
How to Use the Washing Machine
■
Use this program separately from other washing programs. (Do not put
laundry into the tub.)
1. Press the Power button to turn on the power.
2. Select the Tub Dry program.
3. Close the lid and press the Start/Pause button.
■
The tub spins quickly the same as the regular spin cycle to remove the
water from the tub.
■
Use this program separately from other washing programs. (Do not put
laundry into the tub.)
1. Press the Power button to turn on the power.
2. Select the Tub Clean program.
3. Press the Start/Pause button. The washing machine starts pouring
water into the tub.
4. Add tub cleaner, according to the package, to the tub. (Liquid
peroxide-based bleach is also effective as a tub cleaner. Since the
required amount of bleach varies depending on the type of bleach,
follow the instructions on the package of bleach.)
5. Close the lid.
■
Water is added to the maximum level to wash away dirt you cannot see
on the tub and outer tub. After that, Normal Rinse is performed twice to
fl ush out any remaining dirt or tub cleaner.
1. Press the Power button to turn on the power.
2. Select a program.
3. Press the Delay Timer button and select the time to finish washing.
Each press of the button adds an hour starting from 3 hours to
12 hours later.
4. Press the Start/Pause button.
5. Add detergent and close the lid. The power turns off after a short
time.
6. Operations finish at the set time.
■
The Delay Timer is unavailable for the Blanket, Tub Dry, and Tub Clean
programs.
■
To change the setting, press the Power button and do the settings
again.
■
If there is a power outage while the timer is set, the timer setting is
cancelled. If this happens, press the Power button again and reset the
timer.
■
To prevent your laundry from wrinkling, remove it as soon as possible
after washing is done.
13