Faders; Encoders; Buttons And Leds - PRESONUS FaderPort 16 Owner's Manual

9 Appendix
9.3 FaderPort 16 MIDI Protocol

Faders

9.3.2

Encoders

9.3.3
9.3.4

Buttons and LEDs

Button and LED ID Tables:
Use MIDI pitch bend message to transmit fader moves and receive fader positions.
Channel 0-7 are used to address faders 1-8 respectively.
Faders
Transmitted
Fader index
Use CC messages to transmit increment and decrement values.
Transmitted endless rotary encoder delta values:
Pan / Param Encoder: B0, 10, xx
Session Navigator Encoder: B0, 3C, xx
xx delta value bit (Bit 6 = direction, Bits 0-5 = number of steps)
Buttons use Note On/Off messages to transmit the
pressed and released state on channel 0.
LEDs use Note On/Off messages to receive the on,
off and flashing state on channel 0.
Transmitted
Button press and release message
Received (On, Off, Flashing)
LED on / off message
Received (Color)
LED Color message
General Controls (Left Side)
Button Label
Pan / Param Push Encoder
Arm
Solo Clear
Mute Clear
Bypass
Macro
Link
Shift (Left)
Received Ex, ll, hh
Ex, ll, hh
x
Low 7 bits ll
High 7 bits hh
90, id, ss
ID See ID Table
ss State (Release: 00, Pressed, 7F)
90, id, ss
ID See ID Table
ss State (Off: 00, On: 7F, Flashing: 01)
MIDI channel 1-3 is used to set the RGB values of a LED
color with 7-bit resolution per color
Red 91, id, cc
Green 92, id, cc
Blue 93, id, cc
ID See ID table
cc 7-bit color value
ID (Hex)
20
00
01
02
03
04
05
06
FaderPort™ 16
Owner's Manual
LED Type
n/a
LED
LED
LED
RGB
RGB
RGB
LED
63