Important Safety Information - ABB ACF-NT Installation Instructions Manual

Important Safety Information

Proper Operation
Explosion Protection
Requirements for
Safe Operation
Personnel
Qualifications
Special Information
and Precautions
Safety Labels
Affixed to the
Analyzer System
National Regulations
Analyzer System
Safety and Safe
Operation
Additional
Information
4
The ACF-NT analyzer system is designed for continuous measurement of
concentrations of specific components in gases or vapor.
The analyzer system must not be used to measure combustible gas/air or gas/
oxygen mixtures. The analyzer system must not be installed in hazardous locations.
In order to operate in a safe and efficient manner, the analyzer system should be
properly handled and stored, correctly installed and set-up, properly operated and
carefully maintained.
Only persons familiar with the installation, set-up, operation and maintenance of
comparable analyzer systems and certified as being capable of such work should
work on the system.
These include
 The content of this manual.
 The safety labels affixed to the analyzer system.
 The applicable safety precautions for installing and operating electrical devices
 Safety precautions for working with gases, acids, condensates, etc.
Observe the safety labels affixed to the analyzer system:
Consult
Documentation!
The regulations, standards and guidelines cited in this operator's manual are
applicable in the Federal Republic of Germany. The applicable national regulations
should be followed when the analyzer system is used in other countries.
The analyzer system is designed and tested in accordance with EN 61010 Part 1/
IEC 1010-1, "Safety Provisions for Electrical Measuring, Control, Regulation and
Laboratory Instruments" and has been shipped ready for safe operation.
To maintain this condition and to assure safe operation, read and follow the safety
information identified with the symbol
persons at risk and can damage the analyzer system as well as other systems and
instruments.
If the information in this manual does not cover a particular situation, ABB Service
is prepared to supply additional information as needed.
Please contact your local service representative. For emergencies, please contact
ABB Service
Telephone: +49-(0)180-5-222580, Telefax: +49-(0)621-38193129031,
E-mail: automation.service@de.abb.com
Installation Instructions ACF-NT, ACF-NT V0309
Hot Surface!
(Temperature
> 60 °C)
in this manual. Failure to do so can put
42/23-571 EN Rev. 5
Risk of
Electric Shock!