Download Print this page

FUTABA 4PLS Manual page 21

2.4ghz t-fhss radio system
Hide thumbs Also See for 4PLS:

Advertisement

Idle-Up "IDLUP"
This is a function select switch dial function. The idle up ON/OFF switch must be set.
(P65)
This function is used to improve engine starting performance by raising the idling speed
when starting the engine of a gasoline car (boat). It is also effective when you want to
prevent the braking when the power was turned off during running, due to the effect
of your gear ratio setting and choice of motor when operating an electric car. However,
considering safety, and to prevent the motor from rotating instantly when the power was
setting the idle up function switch to ON.
Operation
The throttle neutral position is offset to the forward side or brake side. There is no link-
age locking, etc. because there is no change near the maximum operation angle even
when the neutral position is offset by this function.
Operation Display
While this function is ON, the LED blinks.
< NO SW >
If function's ON/OFF switch
is not selected, <NO SW>
is displayed.
The function select switch
dial screen (p.65) can be
displayed from this screen.
Idle-Up function adjustment
(Preparation)
- Use the function select switch dial to select the switch. (p.65)
1
(Idle-Up rate)
Select the setting item "IDLUP" by the (JOG) button. Use the
(+) and (-) buttons to set the Idle-Up rate.
2
When ending, return to the MENU screen by moving the cur-
sor to the positions other than SW/DIAL and pressing the
(JOG) button
Dial / Trim Setting
The function select dial function can control the Idle-up rate with digital dial or digital
trim. (See page 65)
4PLS-Eng-08-2-Function-P65-83.indd
81
If the power switch is
t u r ned on wh ile t he
idle-up switch is on, an
audible alarm will be
heard. Immediately set
the Idle-Up switch to
OFF.
Throttle Mode "TH MODE"
-
Warning display
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Idle-Up rate (IDLUP)
D50 ~ D1, 0, U1 ~ U50
Initial value: 0
"D": Brake side
"U": Forward side
2013/04/07
81
12:48:18

Advertisement

loading