Advertisement
CPS Mixing "CPS MIX"
This function controls the Futaba CPS-1 channel power switch.
Normally, when using the CPS-1 unit to light the vehicle dress-up and other illumina-
tion (LED) the CPS-1 unit with LED connected is connected to a vacant switch channel
and the LEDs are turned on and off by switch while the vehicle is running. However,
when the CPS-1 mixing (CPS MIX) function is used, the LED can be turned on and off
Setting Special mixings
When the 4th CH was set to ACT at Brake Mixing (p.68) or when Dual ESC Mixing
(p.78) is used, CPS mixing cannot be used.
Display "CPS MIX" screen by the following method:
(HOME screen)
Press
CPS mixing adjustment
(Preparation)
- Connect the CPS-1 to the 4th CH of the receiver.
- When the LEDs are turned on and off by switch, use the
function select switch dial function (p.65) to set the switch to
be used.
78
4PLS-Eng-08-2-Function-P65-83.indd
(MENU 1 screen)
Press
Setup items
MODE : Function ON/OFF, control mode
POSI : ON/OFF position
TYPE : ON/OFF type
TCYCL : Flashing speed
Gyro mixing "CPS MIX"
78
(MENU 2 screen)
Select
"CPS MIX"
(CPS MIX screen)
Press
Press
Function SW
CH4
2013/04/07
12:48:17
Advertisement
