Advertisement
4WS Mixes "4WS"
This function can be used with crawlers and other 4WS type vehicles. It is mixing which
uses the 1st CH to control the front side steering and the 3rd CH to control the rear side
steering.
OFF (front side only), reverse phase, same phase, rear side only and other 4WS type
switching is used by selecting SW1 with the function select switch function (p.65). If
not selected, <NO SW> is displayed. Therefore, select SW1.
Setting Special mixings
When the 3rd CH was set to ACT at Brake Mixing (p.68) or when Gyro Mixing (p.76)
is used, 4WS mixing cannot be used.
Display "4WS" screen by the following method:
(HOME screen)
Press
Reverse phase
4WS mixing adjustment
(Preparation)
Since this function is used by switching the type of 4WS with
a switch, the switch used by the function select switch dial
function (page 65) is set.
72
4PLS-Eng-08-2-Function-P65-83.indd
(MENU 1 screen)
Press
Same phase
4WS Mixes "4WS"
72
(Steering, 3rd channel system)
(MENU 2 screen)
Select
"4WS "
Rear side only
(4WS screen)
Press
Press
Front side only
（4WS OFF）
Setup items
MODE ：4WS Type
RATE ：3ch rate (Rear side)
MXMD ：Mix mode
Function SW
4WS
2013/04/07
12:48:13
Advertisement
