Advertisement
Dual ESC Mixing "DUAL ESC"
This function is mixing used with crawlers and other 4WD type vehicles and uses the
2nd CH to control the front motor controller and the 4th CH to control the rear motor
controller.
Front drive only, rear drive only, or both front and rear drive can be selected using any
programmed DT (digital trim) button.
Setting Special mixings
When the 4th CH was set to ACT at Brake Mixing (p.68) or when CPS Mixing (p.78)
is used, Dual ESC mixing cannot be used.
Display "DUAL ESC" function screen by the following method:.
(HOME screen)
Press
Dual ESC mixing adjustment
(Preparation)
- This function is used to switch between front
drive/4WD/rear drive using one of the dial
(trim). Set the desired dial (trim) for this func-
tion using the SW/DIAL screen (p.65).
1
(Dual ESC setting)
Select the setting item "MODE" by the (JOG) button up or
down operation. Set the function by pressing the (+) or (-)
button.
"INH"
: Function OFF
"ACT" : Function ON
74
4PLS-Eng-08-2-Function-P65-83.indd
(MENU 1 screen)
Press
Dual ESC mixing "DUAL ESC"
74
(MENU 2 screen)
Select
"DUAL ESC "
(Throttle system)
(DUAL ESC screen)
Press
Press
Setup items
MODE : Function ON/OFF
RATE : 4ch rate (Rear side)
MXMD : Mix mode
TRIM : Trim mode
Function SW
ESC-MD
The function select switch
screen (P65) can be dis-
played from this screen.
Function ON/OFF (MODE)
INH, ACT
Select button
- Select with the (+) or (-) but-
tons.
2013/04/07
12:48:14
Advertisement
