Table of Contents
Advertisement
•
•
4. Press the button (E) again and again
until the indicator of the correct level
comes on.
5. To confirm the adjustment, press and
hold buttons (A) and (B) at the same
time for approximately 2 seconds.
7.4 The indicator of the water
container
By default, the indicator of the water
container is on. It comes on when the
programme is completed or when it is
necessary to empty the water container.
If the draining kit is installed
(additional accessory), the
appliance automatically
drains the water from the
water container. In this
condition we recommend
that you deactivate the
indicator of the water
container.
Refer to the supplied
information for available
accessories.
8. BEFORE FIRST USE
Before you use the appliance for the first
time:
• Clean the tumble dryer drum with a
moist cloth.
• Start a short programme (e.g. 30
minutes) with moist laundry.
9. DAILY USE
9.1 Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
the more dry laundry
the standard dry laundry
Deactivating the water
container indicator:
1. Press the on/off button to activate the
appliance.
2. Wait approximately 8 seconds.
3. Press and hold touchpads (J) and (I)
at the same time.
The display shows one of these 2
configurations:
• The indicator
indicator
The indicator of the water
container is off. After
approximately 4 seconds, the 2
indicators go off.
• The indicator
on.
The indicator of the water
container is on. After
approximately 4 seconds, the 2
indicators go off.
At the beginning of the
drying cycle (first 3-5 min)
there could be a slightly
higher sound level. This is
due to the compressor
starting up. This is normal
for compressor powered
appliances such as
refrigerators and freezers.
CAUTION!
Make sure that when
you close the door, the
laundry does not catch
between the appliance
door and the rubber
seal.
2. Press the on/off button to activate the
appliance.
ENGLISH
13
is off and the
is on.
and
are
Advertisement
Table of Contents
