Making Wi-Fi Settings By Pin Code Setup (Wps) - Epson XP-5100 Series User Manual

User's Guide
Related Information
"Basic Operations" on page 17
&
"Checking the Network Connection Status" on page 30
&
"When You Cannot Make Network Settings" on page 164
&

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can automatically connect to an access point by using a PIN code. You can use this method to set up if an
access point is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN code into the access point.
1. Select on the home screen.
To select an item, move the focus to the item using the
2. Select Wi-Fi (Recommended).
3. Press the OK button.
If the network connection is already set up, the connection details are displayed. Select Change Settings to
change the settings.
4. Select Others > PIN Code Setup (WPS).
5. Use your computer to enter the PIN code (an eight digit number) displayed on the printer's control panel into
the access point within two minutes.
Note:
See the documentation provided with your access point for details on entering a PIN code.
6. Press the OK button on the printer.
7. Close the screen.
The screen automatically closes after a specific length of time.
Note:
If connection fails, restart the access point, move it closer to the printer, and try again. If it still does not work, print a
connection report and check the solution.
8. Press the button.
Network Settings
u d l r
buttons, and then press the OK button.
27