Mounting The Ap To A T-Rail - 3Com WL-607 Quick Installation Manual

Figure6 Mount the wall-mounting bracket on the ceiling
(1) Bolt inside the ceiling
(3) Nut
(5) Bolt cap
Step3 Mount the AP9152 to the wall-mounting bracket. For details, refer to Installing
the AP on the wall-mounting bracket.

Mounting the AP to a T-Rail

Note: The width of the T-rail must be in the range of 14 mm (0.55 in) to 24 mm (0.94).
Follow these steps to mount the AP to a T-rail:
Step1 Loosen the two M3 × 6 screws on each clip holder until the screw heads are
lower than the upper edge of the nuts (do not remove the screws or they may
get lost).
Step2 Adjust the T-rail clips to make the T-rail holder wider than the T-rail, and then
lock the T-rail with the T-rail holder according to the arrow
(2) Washer
(4) Wall-mounting bracket
(6) Key-hole clip
ix