Installing The Ap; Temperature And Humidity Requirements; Power Supply - 3Com AP9152 Hardware Installation Manual

Temperature and Humidity Requirements

The operating temperature and humidity requirements are as follows:
Specification
Operating temperature
Storage temperature
Operating humidity (non-condensing)

Power Supply

The AP9152 supports PoE power supply.

3 Installing the AP

Note:
1) Make sure that no metal particles (such as screws) fall into the Ethernet or
console interface during installation.
2) Before installing the AP9152 to the wall-mounting bracket, connect the
network cable. The network cable can only be UTP Cat-5.
3) Before connecting the console cable to the AP9152 for debugging or pressing
the reset button, you need to remove the device from the wall-mounting
bracket.
Determining the Installation Site
Determine the installation site by observing the following principles:
Ensure that there are as few obstacles as possible between the AP and the
wireless stations.
Keep the AP far away from electronic devices (such as microwave ovens) that
may generate RF noise.
Ensure that the installation site will not cause any inconvenience or nuisance.
Note:
1) Make sure the ceiling is strong enough and the structure is suitable for ceiling
mounting. Reinforce the ceiling if needed.
2) Use a Kensington lock if physical security is required to protect the AP from
being stolen.
Installing the AP
The AP9152 supports three installation methods:
Mounting the AP on a Wall
Mounting the AP on a Ceiling
Mounting the AP to a T-Rail
Mounting the AP on a Wall
The following describes how to mount the AP9152 on a wall:
Range
-10°C to 55°C (14°F to 131°F)
–40°C to +70°C (–40°F to +158°F)
5% to 95%
3