TP-Link Archer C3150 User Manual page 88

Chapter 12
Network Destination:
to assign to a static route. This IP address cannot be on the same
subnet with the WAN IP or LAN IP of the router. In the example,
the IP address of the company network is the destination IP
address, so here enters 172.30.30.1.
Subnet Mask: Determines the destination network with the
destination IP address. If the destination is a single IP address,
enter 255.255.255.255; otherwise, enter the subnet mask of
the corresponding network IP. In the example, the destination
network is a single IP, so here enters 255.255.255.255.
Gateway: The IP address of the gateway device to which the data
packets will be sent. This IP address must be on the same subnet
with the router's IP which sends out the data. In the example, the
data packets will be sent to the LAN port of Router 2 and then to
the Server, so the default gateway should be 192.168.0.2.
Interface: Determined by the port (WAN/LAN) that sends out the
data packets. In the example, the data is sent to the gateway
through the LAN port, so LAN should be selected.
Status: Determines the status of the entry. In the example,
Enabled should be selected.
5. Click OK to save the settings.
6. Check the System Routing Table
entry you've set in the
routing is set successfully.
Customize Your Network Settings
The destination IP address that you want
below. If you can find the
System Routing Table, the static
84