Specify Dhcp Server Settings - TP-Link Archer C3150 User Manual

Chapter 12
Done!

12. 4. Specify DHCP Server Settings

By default, the DHCP (Dynamic Host Configuration Protocol) Server is enabled and
the router acts as a DHCP server; it dynamically assigns TCP/IP parameters to client
devices from the IP Address Pool. You can change the settings of the DHCP Server if
necessary, and you can reserve LAN IP addresses for specified client devices.
1 ) Tick the Enable IPTV
2 ) Select the appropriate
Bridge if your ISP is not listed and no other parameters
are required, and then skip to substep 4. Select
your ISP is not listed but provides necessary parameters.
3 ) After you have selected a mode, the necessary
parameters are predetermined. You can perform other
configuration, e.g. enter the
select the IPTV Multicast Vlan Priority
according to your ISP.
4 ) Select the IGMP Proxy
to the information provided by your ISP.
5 ) For Russia, Singapore-ExStream, Malaysia-Unifi and
Malaysia-Maxis modes, connect the set-top box to the
predetermined LAN port. For Bridge and Custom mode,
select the LAN
corresponding port.
6 ) Click Save.
Your IPTV setup is done now! You may need other configurations
on your set-top box before enjoying your TV.
Customize Your Network Settings
check box.
Mode according to your ISP. Select
IPTV Multicast Vlan ID
version, either V2 or V3, according
type and connect the set-top box to the
Custom if
and
in Russia mode
80