Terms And Abbreviations Used; General; Terms And Abbreviations A - C; Terms And Abbreviations D - F - Fronius TransSynergic 5000 Operating Instructions & Spare Parts

Terms and abbreviations used

General

The terms and abbreviations listed here are used in connection with functions that are ei-
ther included in the standard scope of supply or that are available as optional extras.
Terms and abbre-
AL.c
viations A - C
Arc length correction
Up and down correction limits for the arc length (job correction)
AL.1
Arc length correction 1
General arc length correction (job correction)
AL.2
Arc length correction 2
Arc length correction for the upper operating point of the pulsed welding power (Synchro-
Pulse)
Arc
Arc
Arc break watchdog
ASt
Anti-stick
For reducing the effect of a "sticking" rod electrode (MMA welding)
bbc
Burn-back time correction
C-C
Cooling unit cut-out
sition "On" / "Off", the cooling unit remains permanently switched on/switched off. Sepa-
rate adjustment for the MIG/MAG and TIG processes is supported.
COr
Correction
Gas correction ("Digital gas control" option)
CSS
Comfort stop sensitivity
Sensitivity of the response characteristic of the TIG comfort stop function The TIG Com-
fort Stop function supports the TIG welding process without torch trigger. A downslope is
triggered by briefly lifting or lowering the welding torch (ramp decrease of the welding cur-
rent).
C-t
Cooling time
Time from when the flow watchdog is triggered until the "no | H2O" service code is output.
Terms and abbre-
dFd
viations D - F
delta Feeder
Welding power offset for the SynchroPulse option (defined by the wire feed speed)
dYn
dynamic
Arc force dynamic correction for standard arcs, pulse correction for pulsed arcs or correc-
tion of various parameters in CMT (job correction or arc force dynamic and pulse correc-
tion settings in the Setup menu for the Standard control panel)
194
In position "Aut", the cut-out is automatic depending on the coolant temperature. In po-