FIGURE 10 Connecting the power cord
6.
Power on the supply and verify that it is working properly as instructed in
proper operation"
Replacing the fan tray
You can replace the fan tray while the TurboIron 24X is powered on and running. The fan tray is located in a slot at the rear of the
TurboIron 24X.
This section provides information about the following topics:
•
Installation precautions and warnings
•
Replacing the fan tray
Installation precautions and warnings
Follow these precautions when removing and installing a fan tray in the TurboIron 24X.
Be careful not to accidently insert your fingers into the fan tray while removing it from the chassis. The fan
may still be spinning at a high speed.
Do not install the device in an environment where the operating ambient temperature might exceed 40°C
(104°F).
Never leave tools inside the device.
Brocade TurboIron 24X Series Hardware Installation Guide
Part Number: 53-1003053-03
on page 19.
Maintaining the TurboIron 24X Hardware
"Powering on the system"
Replacing the fan tray
on page 18 and
"Verifying
51