Table of Contents
Advertisement
AC power supplies
Use the following procedures for AC power supplies in TurboIron 24X devices.
Before beginning the installation, refer to the precautions in
You will need a #2 Phillips-head screwdriver to perform these procedures.
Figure 3
shows a front view of the AC power supply.
FIGURE 3
AC power supply
Removing an AC power supply
Follow the steps to remove an AC power supply.
1.
Unplug the power cord from the power source.
2.
Disconnect the power cord from the power supply.
3.
Loosen the two captive power supply locking screws located on the sides of the power supply.
FIGURE 4
Releasing the power supply
4.
Hold the handle on the front panel of the power supply and pull outward. This will disconnect the power supply from the
backplane.
5.
Continue to pull the power supply until it is removed from the device.
Brocade TurboIron 24X Series Hardware Installation Guide
Part Number: 53-1003053-03
Maintaining the TurboIron 24X Hardware
Replacing a power supply
"Power precautions"
on page 12.
47
Advertisement
Table of Contents
