Porter-Cable PCXB515BG Instruction Manual page 5

16. REDUCE THE RISK OF
UNINTENTIONAL STARTING. Make
sure switch is in the OFF position before
plugging the tool in.
17. USE RECOMMENDED ACCESSORIES.
Consult this Instruction Manual for
recommended accessories. The use of
improper accessories may cause risk of
injury to yourself or others.
18. NEVER STAND ON THE TOOL. Serious
injury could occur if the tool is tipped
or if the cutting tool is unintentionally
contacted.
19. CHECK FOR DAMAGED PARTS. Before
further use of the tool, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended function
– check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting and any other conditions
that may affect its operation. A guard or
other part that is damaged should be
properly repaired or replaced.
20. NEVER LEAVE THE TOOL RUNNING
UNATTENDED. TURN THE POWER
"OFF". Do not walk away from a running
tool until the blade comes to a complete
stop and the tool is unplugged from the
power source.
21. DO NOT OVERREACH. Keep proper
footing and balance at all times.
22. MAINTAIN TOOLS WITH CARE. Keep
tools sharp and clean for best and safest
performance. Follow instructions for
lubricating and changing accessories.
23. DO NOT use power tool in presence of
flammable liquids or gases.
24. DO NOT operate the tool if you are under
the influence of any drugs, alcohol or
medicationn that could affect your ability
to use the tool properly.
25. Dust generated from certain materials
can be hazardous to your health. Always
operate saw in well-ventilated area and
provide for proper dust removal.
26.
WARNING
!
People with electronic devices, such
as pacemakers, should consult their
physician(s) before using this product.
Operation of electrical equipment in
close proximity to a heart pacemaker
could cause interference or failure of the
pacemaker.
27. WEAR HEARING PROTECTION
to reduce the risk of induced
hearing loss.
28. SERVICE Have your power tool serviced
by a qualified repair person using only
identical replacement parts. This will ensure
that the safety of the power tool is maintained.
29. Do not use the power tool if the switch does
not turn it on and off. Any power tool that cannot
be controlled with the switch is dangerous and
must be repaired.
5