Assembly And Adjustments - Porter-Cable PCXB515BG Instruction Manual

Estimated Assembly Time: 10 - 20 Minutes.
WARNING
!
• To avoid injury, do not connect this
bench grinder to the power source
until it is completely assembled and
adjusted, and you have read and
understood this Instruction Manual.
• To reduce the risk of injury, turn unit
off and disconnect it from power
source before installing and removing
accessories, before adjusting or when
making repairs. An accidental start-up
can cause injury.
INSTALLING TOOL RESTS (FIG. A)
1. Bag "B" - Attach the right tool rest (1) to
the grinder as the upper slot (2) to the
nut (3) and lower slot (4) to the protrude
cylinder (5).
2. Bag "C" - Place the lock knob (6) through
the washer (7) and lower slot (5) into the
hold (8) to lock the tool rest (1) in place.
NOTE: The V grooved tool rest must
mounts on the right side of grinder.
3. Repeat the above steps for installing the
left tool rest.
NOTE: When in use, the tool rests should
be adjusted to within
the grinding wheel or other accessory
being used.
Fig. A
6
Add:
4. Turn the wheels by hand to make
sure there is no contact between the
two grinding wheels and the two tool
rests.

ASSEMBLY AND ADJUSTMENTS

1/8 in. (3.2 mm)
5
8
3
4
7 2
INSTALLING THE LED LIGHT AND EYE
SHIELD ASSEMBLY (FIG. B, C)
1. Bag "F" - Tighten the LED light
assembly (1) to grinder with two
composite screws (2) using a Philips
screwdriver. (Fig. B)
Fig. B
2
2. Bag "D" - Attach one eye shield (3) to
the support bracket (4) of the LED light
assembly.
3. Bag "E" - Tighten the eye shield (3)
by using a carriage bolt (5) and lock
knob (6) as the way shown in Figure C.
4. Repeat the above steps for installing
the other LED light and eye shield
assembly.
of
NOTE: Adjust eye shields to appropriate
distance from tool rests avoiding
interference when operation.
Fig. C
6
1
Add:
5. Turn the wheels by hand
to make sure there is no
contact between the two
grinding wheels and the two
LED light assemblies.
13
1
5
4
3