Temperature Scale Units; Ramp And Soak Program; Number Of Program Set-Points - Fluke 7341 User Manual

7341 Calibration Bath
User's Guide
9.5
9.6
9.6.1
42

Temperature Scale Units

The temperature scale units of the controller may be set by the user to degrees
Celsius (°C) or Fahrenheit (°F). The units are used in displaying the bath tem-
perature, set-point, vernier, proportional band, and cutout set-point.
The temperature scale units selection is accessed after the vernier adjustment
function by pressing "SET". From the temperature display function access the
units selection by pressing "SET" 4 times.
Scale units currently selected
Un= C
Press "UP" or "DOWN" to change the units.
U
Change units
New units selected
Un= F
Press "SET" to accept the new selection and resume displaying the bath
temperature.
S
Set the new units and resume temperature display

Ramp and Soak Program

The ramp and soak program feature allows the user to program a number of
set-points and have the instrument automatically cycle between the tempera-
tures, holding at each for a length of time. The user can select one of four dif-
ferent cycle functions.
The program parameter menu is accessed by pressing "SET" and then "UP".
Well temperature
| 100.00 C
S+U
Access program menu
ProG Program menu
Press "SET" to enter the program menu
S
Enter program menu

Number of Program Set-points

The first parameter in the program menu is the number of set-points to cycle
through. Up to 8 set-points can be used in a ramp and soak program. These