Power - Fluke 7341 User Manual

7341 Calibration Bath
User's Guide
5.6
20
Be sure the fluid expansion reservoir is properly installed checking to insure it
is clean and free of foreign matter. Carefully monitor the bath fluid level as the
bath temperature rises to prevent excessive overflow or splashing. Remove ex-
cess hot fluid if necessary with caution.

Power

With the bath power switch off, plug the bath into an AC mains outlet of the
appropriate voltage, frequency, and current capacity. Refer to Section 3.1,
Specifications, for power details. Refer to and read the CAUTION at the front
of the manual concerning brownout and over voltage protection. Check the
back panel label for the correct voltage and frequency prior to energizing
the bath.