Resetting the Standard Product Default Settings:
Current Application Work Group
If you aren't sure what programming options are in your image scanner, or
you've changed some options and want the standard product default settings
restored, scan the Standard Product Default Settings: Current Application
Group barcode below.
The
Menu Commands
each of the commands (indicated by an asterisk (*) on the programming pages).
Note: Scanning this barcode also causes both the image scanner and the base
to perform a reset and become unlinked. The image scanner must be
placed in its base to re-establish the link before any setup codes are
entered. Refer to
information.
Resetting the Standard Product Default Settings:
All Application Work Groups
The following barcode defaults all of the work groups to the factory settings.
The
Menu Commands
settings for each of the commands (indicated by an asterisk (*) on the
programming pages).
4 - 2
starting on
page 5-4
"Image Scanner Modes"
Standard Product Default Settings:
Current Application Group
Standard Product Default Settings:
All Application Groups
starting on
page 5-4
list the factory default settings for
on page 3-5 for additional
list the standard product default
2020 User's Guide