Connecting The Base With Usb; Connecting The Base With Keyboard Wedge - Honeywell 2020 User Manual

Connecting the Base with USB

A base can be connected to the USB port of a computer.
1. Connect the appropriate interface cable to the base first and then to the
computer. Make sure the cables are secured in the wireways in the bottom
of the base and that the base sits flat on a horizontal surface.
2. Program the base for the USB interface by scanning the appropriate
programming barcode See
3. Verify the base operation by scanning a barcode.
For additional USB programming and technical information, refer to the
Honeywell "USB Application Note," available at

Connecting the Base with Keyboard Wedge

1. Turn off power and disconnect the keyboard cable from the back of the ter-
minal/computer.
1 - 4
page 2-5.
www.honeywell.com/aidc
.
2020 User's Guide