Troubleshooting Base - Honeywell 2020 User Manual

Insert Battery into Charge Sleeve
1. Place the squared-off end of the bat-
tery into the sleeve and slide it until it
stops. The battery contacts should be
showing through the small rectangular
opening in the battery sleeve.
2. Press other end of the battery until you
feel a click.
Charge Battery
With the battery inside the battery charge
sleeve, place the battery charge sleeve into
the base with the battery contacts going in
first and facing up.

Troubleshooting Base

Note: Please visit the Services and Support section of our website
(
www.honeywell.com/aidc
image scanner and the base.
If your base is not functioning properly, review the following troubleshooting
guidelines to try to isolate the problem.
Is the red LED on?
If the red LED isn't illuminated, check that:
• The power cable is connected properly and there is power at the power
source.
• The host system power is on (if external power isn't used).
Is the green LED on?
If the green LED isn't illuminated, check that:
• The image scanner is correctly placed in the base.
• There is external power or 12 volt host power.
• Charge mode is turned on.
7 - 4
) to check for the latest software for both the
(See "Base Charge Mode" on page 3-3)
2020 User's Guide