To rename image scanners with sequential, numeric names, scan the barcodes
below. Scan the Reset code after each name change and wait for the scanner
to re-link to the base before scanning another barcode to rename the next image
scanner.
Alternatively, you may change the name with a barcode command if you cannot
send serial commands to the base. One way to do this is to scan the barcode
below and scan a number for the image scanner name. For example, if you had
7 image scanners to one base, scan the barcode below with the first image
scanner, scan the 1 barcode on the
of this manual and scan Save. Then scan the Reset barcode and wait for the
scanner to re-link to the base before scanning the next barcode. Repeat that
process for image scanner number 2, 3, 4 etc.
2020 User's Guide
0001
0003
0005
0007
Image Scanner Name
Programming Chart
0002
0004
0006
Reset
inside the back cover
3 - 9