Turning Handset On/Off - SCS Sentinel CL-3645 User Manual

Turning Handset On/Off

When the handset is in power off mode and you
place it on the base, it automatically turns on. To
turn the handset on or off in standby mode,
follow these steps:
. 1 To turn the handset on
key until the display is switched on. While the
handset searches for a base, the signal icon
will flash and the following message will be
displayed.
Searching...
. 2 To turn off the handset
pressed until the display disappears.
, r p e s s a n d h o d l h t e
, k e e p h t e k
When the handset has found the base, it will
enter the standby mode, the display will show
handset number or the handset name (if you
have one saved as described on page 22), signal
icon, battery icon and current time. If the
handset is unsuccessful in finding a base, the
handset will behave according to the Out of
Range condition.
Note
:
If the battery power is very low when you
place the handset on the base, the following
message will be displayed.
FULLY CHARGE THE HANDSET BEFORE
USING.
e y
YOU SHOULD
Charging...
EN
46
EN ::: 46