Adjusting Rip Fence Guide Bars
Aligning Rip Fence Guide Bars
1. Position rip fence over right end of main table. While
holding up rear of rip fence engage front end of rip
fence onto the front guide bar. Now lower rip fence
down onto table.
2. Open owners manual so that 8 pages are separated
from the rest of the book. Use these pages like a
feeler gage to set the spacing between the bottom of
the fence and the table top.
3. Rip fence should clear saw table surface just enough
to allow eight pages to slide back and forth under rip
fence. If rip fence is too high or too low, loosen the four
nuts under the table, the screw that secures rip scale
at front of main table and the rip scale hold down
screw. Release table lock, position fence inside table
extension lock lever. Adjust front bar up and down as
required. Wrench tighten front right nut only.
4. Adjust rear guide bar, as noted above. Wrench tighten
rear right nut.
5. Reposition fence over left end main table.
6. Adjust front guide bar up or down as needed so the rip
fence clears the saw table surface just enough to allow
the 8 pages of the owners manual to slide back and
forth underneath the rip fence. Wrench tighten the front
left nut first and then the other remaining two nuts at
the front of the main table.
7. Adjust rear guide bar, as noted above. Wrench tighten
the rear left nut first then the other two nuts at the rear
of the main table.
8. Slide fence left and right over main table to insure
clearance.
9. Tighten rip scale hold down screw.
Aligning Sliding Table Extension
1. Lock table extension lever.
2. Loosen the four nuts underneath the sliding table
extension.
3. Use a combination square to make sure the top of the
sliding table extension is the same height as the main
table.
4. Tighten four nuts. Recheck and readjust if necessary.
Combination Square
19
Owners Manual
8 Pages
Rip Scale
Hold Down