Table of Contents
Advertisement
■ How to Use the Camera
EXPOSURE SETUP
1.BRIGHTNESS
2.SHUTTER
3.AGC
4.SENS-UP
5.RETURN
● SHUTTER : You can select either auto or manual shutter.
- A.FLK : Select this when you experience picture flicker, which can
happen when there is a clash with the frequency of the installed lighting.
- ESC : Select this to control the shutter speed automatically. If ESC
is selected, the shutter speed is automatically controlled depending
on the ambient illumination of the subject.
- MANUAL : You can control shutter speed manually.
(NTSC : 1/60~1/120,000, PAL : 1/50~1/120,000)
Note
• When you use a DC lens, set the shutter mode to A.FLK if colour rolling occurs.
• When the SHUTTER is set to ESC after selecting the Internal Synchronization
Type, the picture may become unstable if the camera faces a bright fluorescent
light. Therefore, take care when choosing the installation position.
• When the SHUTTER is set to MANUAL or A.FLK mode, SENS-UP will be disabled.
● AGC(AUTO GAIN CONTROL) : The higher the gain level, the brighter
the screen - but the higher the noise.
- OFF : Deactivates the AGC function.
- LOW : Allows automatic gain control from 5.3dB to 32dB.
- HIGH : Allows automatic gain control from 5.3dB to 37dB.
● SENS-UP : When it is night or dark, the camera automatically detects
the light level and maintains a clear picture if this mode is activated.
- OFF : Deactivates the SENS-UP function.
- AUTO : Activates the SENS-UP function.
● RETURN : Select this to save the changes in the EXPOSURE menu
and return to the SETUP menu.
Ultra High Resolution Digital Day/Night Vandal Resistant Dome Camera
25
MANUAL
HIGH
AUTO
18
Note
• If you press the SET button in 'AUTO' mode, You can adjust brightness
by increasing or decreasing the shutter speed. (X2~X512)
• Note that the higher the zoom level, the brighter the screen, but the
more likely it is that an after-image will appear.
• Although Noise, Spots, and Whitish symptoms may occur in SENS-UP
operation when the zoom level is increased, this is normal.
White Balance (White Bal.)
Use the White Balance function to adjust the screen colour.
1. When the SETUP menu screen is displayed, select 'White Bal.' by using
the Up and Down buttons so that the arrow indicates 'White Bal.' .
2. Select a desired mode using the Up and Down buttons.
MAIN MENU
1.LENS
2.EXPOSURE
3.WHITE BAL
4.SSDR
5.BACKLIGHT
※ Select one of the following 5 modes, as appropriate for your purpose.
● ATW : Select this when the colour temperature is between 1,700˚K
and 11,000˚K.
● OUTDOOR : Select this when the colour temperature is between
1,700˚K and 11,000˚K. (sodium light inclusion)
● INDOOR : Select this when the colour temperature is between 4,500˚K
and 8,500˚K.
● MANUAL : Select this to fine-tune White Balance manually.
Set White Balance first by using the ATW or AWC mode. After that
switch to MANUAL mode, fine-tune the White Balance and then
press the SET button.
● AWC→SET : To find the optimal luminance level for the current
environment, point the camera towards a sheet of white paper and
press the Function Setup switch. If the environment changes, readjust it.
19
Ultra High Resolution Digital Day/Night Vandal Resistant Dome Camera
DC
ATW
ON
OFF
Advertisement
Table of Contents
