To Activate; To Set At A Desired Speed; To Deactivate; To Resume Speed - Chrysler 2008 Town & Country Owner's Manual

176 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

To Activate:

Push the ON/OFF button (located in the end of the lever)
once and the CRUISE indicator light (located in the
message window of the odometer) will illuminate show-
ing the electronic speed control system is on. To turn the
system OFF, push the ON/OFF button again and the
system and indicator will turn off.
WARNING!
Leaving the Electronic Speed Control system on
when not in use is dangerous. You could accidently
set the system or cause it to go faster than you want.
You could lose control and have an accident. Always
leave the system OFF when you aren't using it.

To Set At A Desired Speed:

When the vehicle has reached the desired speed, press
the SET lever downward and then release. Lift your foot
off the accelerator and the vehicle will operate at the
selected speed.

To Deactivate:

A soft tap on the brake pedal or pulling the lever
CANCEL toward you, will deactivate the speed control
without erasing the set speed memory. Pushing the
ON/OFF button to the OFF position or turning off the
ignition erases the set speed memory.

To Resume Speed:

To resume a previously set speed, raise the lever
RESUME/ACCEL upwards and release. Resume can be
used at any speed above 25 mph (40 km/h).