Table of Contents
Advertisement
Logging in
Through the control
port: stand-alone
Through the control
port: daisy-chained
Logging out
38
Chapter 5: Initial configuration
On a stand-alone unit, the device typically has the address of 00:00:000. In this case, sim-
ply push the Enter key to log in. The IDSU will display the Main menu, and then the com-
mand prompt, indicating you are logged in.
With daisy-chained units, each unit in the daisy chain has an address. To log into an IDSU
that is daisy-chained, enter this:
<Ctrl-D>xx:yy:zzz<Ctrl-E>
where xx:yy:zzz is the address of the unit you want to log into. Note that the colon delimit-
ers are required.
You should always log out of the DataSMART T3/E3 IDSU when you are done, however,
the Auto Logout feature logs you out automatically after 15 minutes with no activity.
To log out, enter <Ctrl-D>.
You can also log out by disconnecting the control port cable.
Advertisement
Table of Contents
Need help?
Do you have a question about the DataSMART T3/E3 IDSU and is the answer not in the manual?
Questions and answers